How to get stm32 driver for windows 7 install#

In the Download dialog box that pops up, click the Program button.Дisconnect from the board using the disconnect icon on the top toolbar (or Target в†’ Disconnect) and then press the reset button on the board, or cycle the power to run the loaded program. ABOV Semiconductor A31G21x Series Device Support, Drivers and Examples.

Click the OK button in this dialog box to load the binary file to the STM32 (shown in the figure below). DFP (Device Family Pack) indicates that a software pack contains support for. Use the Open File icon on the top toolbar (or File в†’ Open file.) to open the binary file to load to the STM32.ДЄfter opening the binary file, a dialog box will pop up stating that the file is not downloaded to the device. In the STM32 ST-LINK Utility window, click the Connect icon on the top toolbar (or Target в†’ Connect). Plug the ST-LINK or evaluation board with embedded ST-LINK into the USB port of the PC. In Windows 7 it can also be found under Start в†’ All Programs в†’ STMicroelectronics в†’ STM32 ST-LINK Utility в†’ STM32 ST-LINK Utility. Plug in the kiss fc in bootloader mode with the boot jumper bridged or boot button pressed go to your windows device manager, in the top menu select view the. Version: 1.3.1 Operating system: Windows XP, Windows Vista, Windows 7 Bits: 32-bit (x86), 64. There will be a link to the utility on the desktop. Model: STM Virtual COM Port Drivers Vendor: STMicroelectronics.

Run the extracted file and go through the installation procedure.

How to get stm32 driver for windows 7 install#

To install the software on a Windows PC, extract the stm32_st-link_utility.exe file from the downloaded zipped file. Installing latest chipset drivers should fix the SM Bus Controller unknown. and that was that Windows needed to have a stub driver installed.

More information and documentation is available under the Design support tab on the ST-LINK/V2 page of the ST Microelectronics website. I am running Windows 7 so I have used the SMBus/I2C/SAA tool from the Fusion. I instead am getting it showing up as Unknown USB Device ( Device Descriptor Request. Download the STM32 ST-LINK utility software.